Moebius Models Frazetta Death Dealer
Building Tips
Here are some in progress photos of the build,
Buddy Build with Gil MonDragon.
Clamps and more clamps for tight seams.
Cut out the eyes for LEDs
Clear red film for eyes
Clamps removed
Head interior cut out alignment pins for LED
Filled injector pins on back of visible saddle
Test fit the body to the horse
Test fit the horse to the base
3mm red LED wired and installed in the head
Aluminum foil used for light block and reflecting
Testing the light
Nice flow effect
Filling seams with 3M blue glazing putty
Sharpening the edge of the axe
Primed with black Badger Stynylrez
Cape will not lay down over his shoulders,
used clamps and 5 minute epoxy to secure the cape.
Ran magnet wire through the body and
horse to the base
More seams to cleanup with red Bondo glazing putty
All seams cleaned up and another airbrushed layer
of black Stynylrez
Large gap of the fit for the cape and shoulders.
Good fit of the cape and right leg
Aves Apoxie Sculpt used to fill the gap on the cape
Axe notched to match Frazetta"s art
Stay tuned for more in progress build
No comments:
Post a Comment